Application:
Ideal for use where Lead-Free* valves are required.
Designed for installation on potable water lines to protect against both
backsiphonage and backpressure of contaminated water into the potable water
supply. Assembly shall provide protection where a potential health hazard
exists.
Standards Compliance:
ASSE® Listed 1013
IAPMO® Listed
CSA® Certified B64.4
AWWA compliant C511
Approved by the Foundation for Cross Connection Control
and Hydraulic Research at the University of Southern California\UL® Classified
(less shut-off valves only, 3/4"-2")
C-UL® Classified (less shut-off valves only,
3/4"-2")
NSF® Listed - Standard 61 & 372*
Certified to NSF/ANSI 372* by IAPMO R&T
*(0.25% MAX. WEIGHTED AVERAGE LEAD CONTENT)
Materials:
Housing Reinforced Nylon, FDA approved
Fasteners Stainless Steel, 300 Series
Elastomers Silicone (FDA Approved)
Buna Nitrile (FDA
Approved)
Internals Delrin, Nylon, NSF Listed
Springs Stainless Steel, 300 series
Ball Valves Cast Bronze, ASTM B 584
Struts Stainless Steel, 300 Series
Typical Installation:
Local codes shall govern installation requirements. To be
installed in accordance with the manufacturers’ instructions and the latest
edition of the Uniform Plumbing Code. Unless otherwise specified, the assembly
shall be mounted at a minimum of 12” (305mm) and a maximum of 30” (762mm) above
adequate drains with sufficient side clearance for testing and maintenance. The
installation shall be made so that no part of the unit can be submerged.