Application
Ideal for use where Lead-Free* valves are required.
Designed for installation on potable water lines to protect against both back
siphonage and backpressure of polluted water into the potable water supply. A
test cock plug is provided to protect against fouling caused by insects, dirt
and debris. Assembly shall provide protection where a potential non-health
hazard exists.
Standards Compliance
• (Unless otherwise noted, applies to 3/4" thru
2" Horizontal)
• ASSE® Listed 1015 (Vertical flow-up:1 1/4" thru
2")
• IAPMO® Listed
• CSA® Certified (Vertical flow-up:1 1/2" &
2")
• AWWA Compliant C510
• Approved by the Foundation for Cross Connection Control
and Hydraulic
Research at the University of Southern California
• Meets the requirements of NSF/ANSI 61*
*(0.25% MAX. WEIGHTED AVERAGE LEAD CONTENT)
Materials
Main valve body Low Lead Cast Bronze ASTM B 584
Access covers Low Lead Cast Bronze ASTM B 584
Fasteners Stainless Steel, 300 Series
Elastomers Silicone (FDA approved)
Buna Nitrile (FDA
approved)
Polymers Noryl™
Springs Stainless steel, 300 series
Test cock cover Plastic
Ball valve handles Stainless steel
Features
Sizes: 3/4", 1", 1 1/4", 1 1/2",
2"
Maximum working water pressure 175 PSI
Maximum working water temperature 180°F
Hydrostatic test pressure 350 PSI
End connections Threaded ANSI B1.20.1
